DIY Double 2 Liter Bottle Tote

Image may be NSFW.
Clik here to view.Here’s an easy sewing project I dreamed up when trying to figure out how to be able to carry more water in an emergency. 2 liter soda bottles are so easy and inexpensive to get, wash, and fill for emergencies, but they are difficult to carry if you need to leave and take your water with you. The design is based loosely on an 18th century market wallet. This is a beginner level sewing project and you can probably get one of these made in less than 30 minutes. It requires just under a half a yard of fabric, so you may even already have some scraps you can use if you do any other type of sewing or quilting!

What you need:

1/2 yard 44-45″ cotton quilting fabric. (If you want to use a heavier fabric, you may be able to use 1/4 yard, skip to step 7 and just hem the raw edges and have your tote a single thickness of fabric instead of doubled.)
Thread. Make it matching thread if you want it to look pretty, but if it’s just to haul emergency water the thread doesn’t really have to match. ;-)
A sewing machine will make this easier, but it could also be hand sewn.

Need a sewing machine? Here’s a better-than-beginner model for under $150! Want one that will run without power? Check out the Janome 712T modern treadle machine.

Let’s get started.

1. Lay your fabric out (mine was more than 1/2 yard) and measure along the selvedge edge (the uncut side) 17 inches. Cut across to the opposite selvedge edge so you have a piece that is 17″ x 45″.

Image may be NSFW.
Clik here to view.

2. Fold the piece right side together to make a long skinny piece.

Image may be NSFW.
Clik here to view.

3. Pin and sew together with a 1/2 inch seam allowance along one short edge and the long edge, leaving the second short edge open.

Image may be NSFW.
Clik here to view.

4. Clip the corners you just sewed (I marked the sewing lines in the photo), and turn the tube right side out through the open edge.

Image may be NSFW.
Clik here to view.

5. Press flat.

Image may be NSFW.
Clik here to view.

6. Turn the open edge in approximately 1/2 inch or enough to hide the selvedge printing and press.

Image may be NSFW.
Clik here to view.

7. Fold each end toward the middle at the 9 inch mark and press. These will be your pockets.

Image may be NSFW.
Clik here to view.

8. Top stitch the open end shut.

Image may be NSFW.
Clik here to view.

9. Stitch the pockets up on each side with a 3/8 inch seam allowance–about the width of the presser foot. The photo shows a wider seam, but it’s better to do this seam a little smaller than pictured so the bottles slide in easier. And my hand is only there to show that it’s the pocket, I didn’t actually run the machine with my hand there!

Image may be NSFW.
Clik here to view.

10. Turn the pockets so the seam in on the inside.

Image may be NSFW.
Clik here to view.

11. Insert bottles filled with water and you’re ready to go! Now you can easily carry two in one hand, or thread the tote through the shoulder or handle strap of your go bag (one pocket on each side of the strap) before inserting the bottles or attach the tote to your bag with a carabiner and they’ll hang from the strap so you don’t need to use a hand to carry them at all!

Image may be NSFW.
Clik here to view.